by John Brown, HaveFunBiking.com
Biking in the rain as spring arrives, staying dry is the most important and difficult part of riding. The best way to keep dry is to wear waterproof clothing. While most synthetic fabrics still insulate when wet, being wet diminishes their ability to keep you warm. Therefore, a waterproof jacket and pants are a great way to start, but waterproof socks and gloves make the outfit complete. While a lot of materials are naturally waterproof, once perforated with stitching, zipped closed with generic zippers, and left to be loose at all the cuffs, their waterproofing goes out the window. Before you go out and buy anything labeled “waterproof,” read on to understand that all waterproofing is not the same.
Waterproof Clothing and Gear for Staying Dry
To keep water out, look for waterproof clothes that have sealed or welded seams (see image). Also, look for waterproof zippers (pictured) or large flaps that prevent water from driving through the zipper. Make sure all the cuffs are adjustable enough to be snugged tight against your skin.
A waterproof garment is measured in mm of fluid. For example, a fabric that was 5,000 mm waterproof is tested as follows. The fabric is placed over the end of a long tube. Following that, the tube is filled with 5,000 mm of water and the fabric needs to support the pressure without leaking. Take a look at the table below for a quick reference.
|0 mm – 1,500 mm||Water resistant/snowproof||Dry conditions or very light rain|
|1,500 mm – 5,000 mm||Waterproof||Light to average rain|
|5,000 mm – 10,000 mm||Very Waterproof||Moderate to heavy rain|
|10,000 mm- 20,000 mm||Highly Waterproof||Heavy rain|
Breathe Sweat Out
In addition to measuring waterproofness, textiles are also measured for their ability to breath water vapor out. Breathable means that water vapor (sweat) being produced by your body can escape through the fabric. Breathable fabrics work because water vapor is smaller than water droplets. In order to breath, the material will be perforated with holes small enough to stop water droplets from getting in, but large enough to allow water vapor to escape.
Breathability is important because, as far as insulation is concerned, it’s just as bad to get soaked with sweat as with rain. Therefore, using a breathable material in tandem with base layers designed to pull moisture off your skin is a sure fire way to stay dry and warm.
Breathability is expressed in terms of how many grams (g) of water vapor can pass through a square meter (m2) of the fabric from the inside to the outside in a 24 hour period. To that effect, the larger the number, the more breathable the fabric. For example, a coat with 5,000 gsm breathability, 5,000 grams of water pass through a square meter of the fabric.
Waterproof even when it isn’t raining
During the spring thaw snow melts during the day and freezes again at night. In my commutes, during the thaw, I focus on wearing waterproof clothing to keep warm. The rivers of salty water I end up riding through would soak any non-waterproof clothing rendering it useless.
When Waterproof is Not Important
As the temperature rises, waterproofing becomes less and less important. It’s less important because, at a certain temperature, waterproof materials cannot breathe enough to keep you dry. Therefore, if it rains hard enough, and it’s warm enough, you’re going to get wet.
In the spring and fall, be sure to have your waterproof gear ready. The cool temps and wet conditions can be very dangerous if you aren’t prepared. Being dry is the #1 way to maintain your comfort and safety while riding in inclement conditions.